13 Gas Faults And Error Messages; Err 08-01 (No Gas) - Henny Penny FlexFusion FGE 615 Service Instructions Manual

Gas faults and error messages
13 Gas faults and error messages

13.1 Err 08-01 (no gas)

Description This error message only appears if on the first gas request on
Prerequisite •
Troubleshooting Remove the left side wall.
INFORMATION
76
program start there is no response.
Ensure customer-supplied gas supply according to installation
instructions.
• The connection pressure and the flow pressure are always within
the specifications. For this, the gas pressure must be measured
on the gas magnetic valve. Here the maximum gas requirement of
all appliances connected to the gas supply must be considered.
Also make pressure measurements with maximum loading of the
gas supply.
• The installed gas plate is correct.
1. Start cooking program.
Ignition is occurring.
The ionization electrode or the ignition electronics does not detect
the flame.
2. Start cooking program.
Ignition is not occurring. The glow electrode does not light up
(visual inspection).
Check the voltage and fuses on the transformer, ignition
electrode, and glow electrode.
3. Start cooking program.
Ignition is not occurring. The glow electrode is functioning
properly.
Check gas fan for proper operation.
Check the gas solenoid valve. Visually inspect and check the gas
heat exchanger in the cooking chamber for leaks.
4. Start cooking program.
Ignition is not occurring. The glow electrode is functioning
properly.
The ignition electronics are defective and do not activate the gas
magnetic valve.
Perform troubleshooting using the Service menu, CO
where all requirements and responses are displayed.
Service instructions
calibration. This is
2