Henny Penny FlexFusion FGE 615 Service Instructions Manual page 45

a
Image: Setting the rated heat input
a Adjusting screw for minimum
capacity / low output (TX40)
1. Switch on the unit.
2. Open CO settings .
2
3. Press the "START STOP" button.
4. Using the left knob, set the burner to low output ("LO").
The left display flashes "LO".
The centre display shows "CO2".
5. Use the right knob to select the first burner "-1-" (on models with
two burners).
The right display flashes "-1-".
6. Press the "START STOP" button.
The indicator light in the "START STOP" button flashes; the
burner starts.
The unit operates under partial load.
7. Press the Ready2Cook button.
The left display shows the current temperature in the cooking
chamber.
The center display shows the selected burner "-1-" (on models
with two burners).
The right display shows the current status of the burner
("G1F1").
8. Measure the exhaust gas values with an approved exhaust gas
measuring device once the operating temperature is reached.
To regulate the cooking chamber temperature, open the
cooking chamber door slightly.
9. Check whether the measured CO
range.
10.Using the adjusting screw for minimum output, adjust the CO
content to the specified range for low output (setting is very
sensitive).
Turning counterclockwise: CO
Turning clockwise: CO
Service instructions
content is within the specified
2
content is decreased.
2
content is increased.
2
Gas technology
2
45