Extech Instruments MS6100 User Manual page 24

3. Each option in HORI MENU is described as follows:
Options
Window Control (F1)
(Menu page 1)
Window Selection (F2)
(menu page 1)
Holdoff (F3)
(menu page 1)
Reset (F4)
(menu page 1)
Page (F5)
Pre Mark (F2)
(menu page 2)
Next Mark (F3)
(menu page 2)
Set/Clear (F4)
(menu page 2)
Clear All (F2)
(menu page 3)
Play/Stop (F3)
(menu page 3)
Settings
Double Window Selects either Single or Double window mode (see figures
Single Window below table). Press this option button in single-window
mode to enter the dual-window mode.
Major Window Selects the major (upper) or minor (lower) window in
Minor Window dual-window mode. The window is highlighted once
selected.
Select this menu and click the up and down Arrow keys to
adjust the trigger hold-off time within the range of
100ns-10s.
Change Menu pages 1 to 3 when Window Control is set to
Double Window
Used when Marks are set in place. This button will position
the display to view the signal at any marks to the Left of your
present view.
Used when Marks are set in place. This button will position
the display to view the signal at any marks to the Right of
your present view.
Sets a mark or Clears the indicated mark. To place a Mark
on the signal, place that portion of the signal to be observed
at the center verticle line (Bottom window) using the
Horizontal Position button. Press the Set button to add or
remove that mark.
Clear all Marks
Push this button to auto move the signal from left to right.
Set the signal window to the left most position using the
Horizontal position button. Press Play to start the signal
moving across the screen.
movement.
www.burntec.com
Comments
24
Press Stop to halt the
MS6000-EU-EN-V1.3 7/12