6.
Set the link refresh settings as follows.
[Navigation window] [Parameter] [Module Information] [RJ61BT11] [Basic Settings] [Link Refresh Settings]
7.
Set the supplementary cyclic settings as follows.
[Navigation window] [Parameter] [Module Information] [RJ61BT11] [Application Settings] [Supplementary
Cyclic Settings]
8.
Write the set parameters to the CPU module on the standby master station. Then reset the CPU module or power off and
on the system.
[Online] [Write to PLC]
In this example, default values are used for parameters that are not shown above. For the parameter setting,
refer to the chapter explaining the parameters in this manual. ( Page 54 PARAMETER SETTINGS)
3.3 Communication Example Using the Standby Master Function
3 PROGRAMMING
91
3