2
PARAMETER SETTINGS
This chapter describes the parameter settings required for the master/local module.
2.1
Setting Parameters
1.
Add the master/local module in the engineering tool.
[Navigation window] [Parameter] [Module Information] Right-click [Add New Module]
2.
The required setting, basic setting, and application setting are included in the parameter settings. Select one of the
settings from the tree structure on the window shown below and set parameters.
[Navigation window] [Parameter] [Module Information] [RJ61BT11]
3.
After setting parameters, click the [Apply] button.
4.
Write the settings to the CPU module using the engineering tool.
[Online] [Write to PLC]
5.
The settings are reflected by resetting the CPU module or remote head module, or powering off and on the system.
2 PARAMETER SETTINGS
54
2.1 Setting Parameters