6.
Set the link refresh settings as follows.
[Navigation window] [Parameter] [Module Information] [RJ61BT11] [Basic Settings] [Link Refresh Settings]
7.
Set the supplementary cyclic settings as follows.
[Navigation window] [Parameter] [Module Information] [RJ61BT11] [Application Settings] [Supplementary
Cyclic Settings]
8.
Write the set parameters to the CPU module on the local station. Then reset the CPU module or power off and on the
system.
[Online] [Write to PLC]
In this example, default values are used for parameters that are not shown above. For the parameter setting,
refer to the chapter explaining the parameters in this manual. ( Page 54 PARAMETER SETTINGS)
3 PROGRAMMING
80
3.2 Example of Communications Between a Master Station and a Local Station