Mitsubishi Electric MELSEC iQ-R Series User Manual page 68

6.
When the initial settings are completed for all the set stations, 'Completion status of remote device station initialization
procedure' (SB005F) is turned on.
The stations where the initial settings are completed can be checked with 'Remote device station initialization procedure
registration completion status' (SW0164 to SW0167). ( Page 158 List of link special register (SW) areas)
Also, the execution results are stored in 'Remote device station initialization procedure registration instruction result'
(SW005F). The data stored in 'Remote device station initialization procedure registration execution individual information'
(buffer memory address: Un\G23680 to Un\G23743) become FFH. ( indicates the target station number for the initial
settings.)
7.
Turn off 'Remote device station initialization procedure registration instruction' (SB000D).
'Remote device station initialization procedure registration instruction result' (SW005F) and 'Remote device station
initialization procedure registration execution individual information' (buffer memory address: Un\G23680 to Un\G23743) are
cleared.
■Timing chart
The following figure shows the operations of a link special relay (SB) and link special register (SW) when the remote device
station initialization procedure registration is performed.
'Specification of remote device
station to be initialized'
'Remote device station initialization
procedure registration instruction'
'Execution status of remote device
station initialization procedure'
'Completion status of remote device
station initialization procedure'
'Remote device station initialization
procedure registration execution
individual information'
2 PARAMETER SETTINGS
66
2.3 Basic Settings
SW0014
·
SW0017
SB000D
OFF
SB005E
OFF
SB005F
OFF
Un\23680
·
Un\23743
Executed by the master/local module
Executed on the program
ON
ON
ON