Establishing Authentication; Configuring Refresh Interval; Additional Sip Services - Cisco 7905G Administrator's Manual

Additional SIP Services

Establishing Authentication

Configuring Refresh Interval

Additional SIP Services
Note
Cisco IP Phone Models 7905G and 7912G Administrator Guide (SIP)
4-4
The UseLoginID parameter lets you select the user ID for authentication of the
phone to the remote end as follows:
• If UseLoginID is set to 0, the user ID (set with the UID parameter) is used
with a user-supplied password (set with the PWD parameter) for
authentication.
If UseLoginID is set to 1, you must supply a login ID (set with the LoginID
•
parameter) and a password (set with the PWD parameter) for authentication.
When the value specified with the CfgInterval parameter is reached, the
Cisco IP Phone attempts to refresh its configuration file from the TFTP server.
(You can manually perform a refresh before the scheduled refresh as explained in
the "Refreshing the Cisco IP Phone" section on page
When a Cisco IP Phone contacts the TFTP server, it also checks to see if a
firmware image has been placed on the TFTP server. If such an image exists, the
phone will download this image.
Table 4-2 describes additional SIP services and provides references to additional
information. These services are listed alphabetically.
Many of the descriptions in
in a profile or from a phone's web page. For the corresponding parameter in the
phone configuration menus, see
Profile Equivalent Parameters."
Chapter 4
Table 4-2 refer to specific parameters that you can set
Appendix B, "Phone Menu, Web Page, and
Basic and Additional SIP Services
6-17.)
OL-4277-01