Cisco 7905G Administrator's Manual page 129

Chapter 8 Profile and Web Page Parameters and Defaults
Table 8-2 SIP Parameters (continued)
Parameter
SIPRegInterval
MAXRedirect
SIPRegOn
NATIP
SIPPort
OL-4277-01
Description
SIP registration interval, in seconds, between each registration renewal to the
SIP proxy server. If set to 0, the phone uses the default value.
The value can range from 0 to 86400.
Value type: Integer.
Default value: 3600
Maximum number of redirections the phone attempts to reach a callee.
The value can range from 0 to 10.
Value type: Integer.
Default value: 5
Whether to enable SIP registration. This parameter is ignored if a SIP proxy
server is not specified. If set to 1, the phone periodically registers to the SIP
proxy server at an interval given by the SIPRegInterval parameter.
Valid values are 0 or 1.
Value type: Boolean.
Default value: 0
Network Address Translation (NAT) WAN IP address where other SIP user
agents can communicate with the phone.
Value type: IP address.
Default value: 0.0.0.0
Port where the phone listens for incoming requests and sends outgoing
requests.
Valid values are 5060 to 65535.
Value type: Integer.
Default value: 5060
Cisco IP Phone Models 7905G and 7912G Administrator Guide (SIP)
SIP Parameters
8-11