Making Settings Manually - Cisco 7905G Administrator's Manual

Minimum Configuration Settings for the Cisco IP Phone Models 7905G and 7912G

Making Settings Manually

Cisco IP Phone Models 7905G and 7912G Administrator Guide (SIP)
3-10
Chapter 3
If your network does not use a DHCP server, you must manually specify the IP
address of the phone, the subnet mask used by the phone, and the network gateway
(default router) IP address for the phone. You can specify this information using
the phone's Network Configuration menu, using a profile, or using a phone's web
page.
When you manually specify these values, you must disable DHCP by using the
DHCP Enabled parameter on the Network Configuration menu or the Dhcp
parameter in a profile or web page.
To manually specify the IP address, subnet mask, and default router IP address,
use these parameters:
Setting
IP address of a phone
Subnet mask used by
the phone
Network gateway
(default router) IP
address used by the
phone
For detailed information about configuring menus on the phone, see
"Configuring the Cisco IP Phone Models 7905G and 7912G Using the Phone
Menus."
For detailed information about configuring through profiles, see
"Configuring the Cisco IP Phone Models 7905G and 7912G Using a TFTP
Server."
For detailed information about configuring through a phone's web page, see
Chapter 7, "Configuring the Cisco IP Phone Models 7905G and 7912G Using
Web Pages."
Configuring the Cisco IP Phone Models 7905G and 7912G for SIP
Parameter on Network
Configuration Menu
IP Address
Subnet Mask
Default Router
Parameter in Profile or on
Web Page
StaticIP
StaticNetMask
StaticRoute
Chapter 5,
Chapter 6,
OL-4277-01