Audio Parameters - Cisco 7905G Administrator's Manual

Audio Parameters

Table 8-4 Tone Parameters (continued)
Parameter
ReorderTone
RingBackTone
CallWaitTone
Audio Parameters
Tip
Cisco IP Phone Models 7905G and 7912G Administrator Guide (SIP)
8-24
Description
Tone that plays when the called number does not exist or when the external
network circuit is busy.
See the "ReorderTone Parameter Details" section on page 8-30
usage details.
Value type: Array of 17 short integers.
Default value: 0,2,30467,1104,28959,1404,0,0,1,2000,2000,0,0,0,0,0,0
Tone that plays when the called party's line is ringing.
See the "BusyTone, CallWaitTone, DialTone, DialTone2, and RingBackTone
Parameter Details" section on page 8-28
Value type: Array of 11 short integers.
Default value: 2,30831,2032,30467,1104,1,16000,32000,0,0,0
Tone that plays to indicate that you have a call waiting.
See the "BusyTone, CallWaitTone, DialTone, DialTone2, and RingBackTone
Parameter Details" section on page 8-28
Value type: Array of 11 short integers.
Default value: 1,30831,2412,0,0,1,2400,2400,0,0,4800
Table 8-5 describes the audio parameters that you can configure through a phone's
profile or through the Audio Parameters area on the phone's web page. These
parameters that specify encoding and other audio characteristics for the
Cisco IP Phone.
To access the Audio Parameters area directly from the a browser, enter
IP_address/AudioConfiguration, where IP_address is the IP address of your
Cisco IP Phone.
Chapter 8 Profile and Web Page Parameters and Defaults
for syntax and usage details.
for syntax and usage details.
for syntax and
OL-4277-01