Cisco 7905G Administrator's Manual page 133

Chapter 8 Profile and Web Page Parameters and Defaults
Table 8-3 Call Preference Parameters (continued)
Parameter
Block Caller ID
(on web page)
BlockCallerId
(in profile)
Block Anonymous
Calls
(on web page)
BlockAnonymous
(in profile)
Do Not Disturb
(on web page)
DoNotDisturb
(in profile)
Voice Mail Number
(on web page)
VoiceMailNumber
(in profile)
OL-4277-01
Description
Whether a phone's caller ID information, which includes the value specified
by the Display Name parameter and the phone number, is sent with an outgoing
call. If this parameter is enabled, outgoing calls will use "Anonymous" as the
phone's caller ID.
0=Do not block outgoing caller ID information.
•
• 1=Block outgoing caller ID information.
Value type: Boolean.
Default value: 0
Whether a phone rejects (blocks) an incoming call with "Anonymous" caller
ID will be rejected.
0=Do not block anonymous incoming calls.
•
1=Block anonymous incoming calls.
•
Value type: Boolean.
Default value: 0
Whether the Do Not Disturb feature is enabled on a phone. If this feature is
enabled, calls to the phone will receive a busy signal.
0=Disable the do not disturb feature.
•
• 1=Enable the do not disturb feature.
Value type: Boolean.
Default value: 0
Specifies a telephone number where voice messages are stored and retrieved.
If a number (other than 0) is specified:
• The Message softkey will appear on the phone when appropriate.
Incoming calls forward to this number if the phone is busy or if the calls
•
are not answered within the number of seconds specified with the Forward
to VMail Delay(s) parameter.
Value type: Alphanumeric string, up to 31 characters.
Default value: 0 (disables this feature)
Cisco IP Phone Models 7905G and 7912G Administrator Guide (SIP)
Call Preference Parameters
8-15