Custom Labeling Of Leds - GE C70 Instruction Manual
Capacitor bank protection and control system
Hide thumbs
Also See for C70:
- Instruction manual (708 pages) ,
- Communications manual (532 pages) ,
- Instruction manual (546 pages)
Table of Contents
Advertisement
4 HUMAN INTERFACES
•
GROUP 1...6: The illuminated GROUP is the active settings group.
The relay is shipped with the default label for the LED panel 2. The LEDs, however, are not pre-programmed. To match the
pre-printed label, the LED settings must be entered as shown in the User-programmable LEDs section of chapter 5. The
LEDs are fully user-programmable. The default labels can be replaced by user-printed labels for both panels as explained
in the following section.
a) ENHANCED FACEPLATE
The following procedure requires these pre-requisites:
•
EnerVista UR Setup software is installed and operational
•
The C70 settings have been saved to a settings file
•
The C70 front panel label cutout sheet (GE Multilin part number 1006-0047) has been downloaded from
http://www.gedigitalenergy.com/products/support/ur/URLEDenhanced.doc
•
Small-bladed knife
To create custom LED labels for the enhanced front panel display:
1.
Start the EnerVista UR Setup software.
2.
Select the Front Panel Report item at the bottom of the menu tree for the settings file. The front panel report window
displays.
GE Multilin
SETTINGS IN USE
Figure 4–21: LED PANEL 2 (DEFAULT LABELS)
Figure 4–22: FRONT PANEL REPORT WINDOW
C70 Capacitor Bank Protection and Control System
4.3 FACEPLATE INTERFACE
842783A1.CDR
4.3.3 CUSTOM LABELING OF LEDS
and printed
4
4-17
Advertisement
Table of Contents
