Custom Labeling Of Leds - GE T60 Instruction Manual

4 HUMAN INTERFACES
USER-PROGRAMMABLE LEDS
DEFAULT LABELS FOR LED PANEL 2:
The default labels are intended to represent:
• GROUP 1...6: The illuminated GROUP is the active settings group.
• SYNCHROCHECK NO1(4) IN-SYNCH: Voltages have satisfied the synchrocheck element.
Firmware revisions 2.9x and earlier support eight user setting groups; revisions 3.0x and higher support six setting
groups. For convenience of users using earlier firmware revisions, the relay panel shows eight setting groups.
Please note that the LEDs, despite their default labels, are fully user-programmable.
NOTE
The relay is shipped with the default label for the LED panel 2. The LEDs, however, are not pre-programmed. To match the
pre-printed label, the LED settings must be entered as shown in the User-programmable LEDs section of chapter 5. The
LEDs are fully user-programmable. The default labels can be replaced by user-printed labels for both panels as explained
in the following section.
a) ENHANCED FACEPLATE
The following procedure requires these pre-requisites:
• EnerVista UR Setup software is installed and operational
• The T60 settings have been saved to a settings file
• The T60 front panel label cutout sheet (GE Multilin part number 1006-0047) has been downloaded from
http://www.gegridsolutions.com/products/support/ur/URLEDenhanced.doc
• Small-bladed knife
To create custom LED labels for the enhanced front panel display:
1. Start the EnerVista UR Setup software.
GE Multilin
Figure 4–20: LED PANELS 2 AND 3 (INDEX TEMPLATE)
Figure 4–21: LED PANEL 2 (DEFAULT LABELS)
T60 Transformer Protection System
4.3 FACEPLATE INTERFACE
USER-PROGRAMMABLE LEDS

4.3.3 CUSTOM LABELING OF LEDS

and printed
842782A1.CDR
4
4-17