Creating A New Job In The Memory Or Copying A Job - EWM TETRIX 1002 DC SYNERGIC Operating Instructions Manual

5.6.2

Creating a new JOB in the memory or copying a JOB

It is normally possible to adjust all 256 JOBs individually. However, it is a good idea to
assign specific JOB numbers in the free memory (JOB 128 to 256) for specific welding
tasks.
Copying a pre-defined welding task from the fixed memory (JOBs 1 to 128) to the free memory
(JOBs 129-256):
Define welding task which most closely matches the required application.
Operating Action
element
x x
VOLT
JOB
PROG
2 sec.
VOLT
JOB
PROG
1 x
VOLT
JOB
PROG
1 x
VOLT
JOB
PROG
Item No.: 099-000155-EWM01
NOTE
NOTE
Result
Select JOB Manager mode
Select JOB Manager mode
Switch from "Load JOB" to "Copy JOB"
Select the required JOB number using the rotary
transducer (e.g. 150)
JOB has been copied to the free memory, machine
switches back to Display mode. The JOB can be
modified individually.
Functional characteristics
Organising welding tasks (Mode "JOB Manager")
Display
Press until the "VOLT"
signal light is on
Current value and JOB
number displayed
35