EWM TETRIX 1002 DC SYNERGIC Operating Instructions Manual page 17

Item Symbol Description
1
0
2
3
4
5
6
7
COM
8
9
10
Item No.: 099-000155-EWM01
0
Machine control
See Machine control – operating elements chapter
Key switch for protection against unauthorised use
Position "1" > changes possible,
1
Position "0" > changes not possible.
Please take note of chapter "Key switch"
Main switch, machine on/off
"Operating state" display
Lights up when the machine is switched on and ready for operation
"Fault" display
"Collective interference" signal light
If the signal light is on, the power unit is automatically switched off. Because some
interference is short-term and one-off (e.g. excess mains voltage), the signal light will
go off again and the welding machine will be ready for welding. If the signal light is still
on after a reasonable amount of time, see the chapter on "Operating errors, causes
and remedies".
Arc is burning (welding current flows)
PC interface, serial (D-SUB connection socket, 9-pole)
7-pole connection socket (digital)
For connecting digital accessory components
19-pole connection socket (digital)
Operating panel connection lead connection
ROB XX2 pallet
Transport pallet (option)
Machine description
TETRIX 1002 DC SYNERGIC
17