Verifying Correct Initial Setup Of The Probe - BridgeTech VB20 User Manual

4.10.3 Verifying Correct Initial Setup of the Probe

Once the probe network interfaces have been configured, all further configuration
takes place through HTTP.
1. Launch a WEB-browser application on the management PC.
The following WEB-browsers are tested:
Internet Explorer 7 or higher in Compatibility View
•
Firefox
•
Opera and Chrome are also known to function.
2. Type the IP-address of the probe in the browser URL field and press
<ENTER>.
The IP-address of the probe is that of the eth0 or eth2 port (the one used for
management) as set in the initial set-up procedure.
The default management view should be displayed inside the browser. This could look
similar to the screen shot shown below depending on the options and interfaces
installed.
2014 © BRIDGE Technologies Co AS - Bentsebrugata 20 - N-0476 Oslo, Norway - tel: +47 22 38 51 00 -
40
PROBE USERS' MANUAL VERSION 5.0
www.bridgetech.tv