Rate:
Unreferenced
PID:
SDT: Enable or disable alarming of Service Description Table errors.
SDT - Maximum
interval Actual
(ms):
SDT - Maximum
interval Other
(ms):
SDT - Minimum
gap interval
(ms):
SDT - Verify
SDT against
PAT:
SDT - Require
service name:
SDT - Require
BAT Presence:
EIT: Enable or disable alarming of Event Information Table errors.
EIT - Maximum
interval Actual
(ms):
EIT - Minimum
gap interval
(ms):
EIT - Required
Table IDs:
2014 © BRIDGE Technologies Co AS - Bentsebrugata 20 - N-0476 Oslo, Norway - tel: +47 22 38 51 00 -
Enable or disable alarming of Unreferenced PID errors.
Only relevant when DVB mode is selected.
The maximum allowed section repetition interval for the SDT
Actual table.
Default: 2 000 ms
The maximum allowed section repetition interval for the SDT
Other table.
Default: 10 000 ms
The minimum allowed section gap interval for the SDT table.
Default: 25 ms
If enabled an alarm will be generated if a service found in the
PAT is not listed in the SDT.
Default: Disabled
If enabled an alarm will be generated if a service found in the
PAT does not have a service name or if the service name is
empty.
Default: Disabled
If enabled an alarm will be generated if BAT is not present in the
stream.
Default: Disabled
Only relevant when DVB mode is selected.
The maximum allowed section repetition interval for the EIT
Actual table.
Default: 2 000 ms
The minimum allowed section gap interval for the EIT tables.
Default: 25 ms
If one or more table IDs are specified an alarm will be generated
if these table IDs are not present in the stream on the EIT PID.
Entries should be separated by commas, or a range may be
specified. Example: '78,79,80-85'
Default: Disabled
PROBE USERS' MANUAL VERSION 5.0
www.bridgetech.tv
149