Setup - BridgeTech VB20 User Manual

Enable on eth0: If enabled probe will use VLAN tagging for the
Native VLAN ID: Provided Enable on eth0 is enabled, the probe will send and
Force all VLANs: If enabled together with Enable on eth0 the probe will see
Community string: The probe SNMP community string can be changed.
Trap destination
1-3:
6.17.2 Setup - Pages
The Setup – Pages view allows names to be associated with different pages. This
facilitates navigation in the Mon views.
2014 © BRIDGE Technologies Co AS - Bentsebrugata 20 - N-0476 Oslo, Norway - tel: +47 22 38 51 00 -
TOT. For countries with more than one time zone the region
ID is specified by adding a colon and the region ID to the
country code (e.g. 'USA:2' for country USA and region ID 2).
802.1Q VLAN tagging
data/monitoring interface eth0. Changing this parameter
requires the probe to reboot to take effect.
receive traffic on the VLAN-ID entered here.
all VLAN tagged traffic and not only traffic with the Native
VLAN ID tag. The Mon/Detect list will be able to detect and
list all VLAN tagged traffic. Note that the probe will only
issue IGMP messages on the native VLAN ID, and traffic
tagged differently must be present at the interface to be
detected.
SNMP
SNMP traps will be sent to the specified destinations. Set to
0.0.0.0 to disable SNMP trap transmission.
PROBE USERS' MANUAL VERSION 5.0
www.bridgetech.tv
221