BridgeTech VB20 User Manual page 205

BER (post
Viterbi/LDPC-BCH):
Packet error count: The number of erroneous packets after FEC. Packet errors
Signal to noise
ratio:
Front-end lock: A "bulb" indicating front end lock when green, red indicates
Level: This is a measure of the stream signal power. It is
Setup name: A name should be assigned to each frequency channel
ETR thresholds: The name of the ETR threshold template assigned to the
PID thresholds: The name of the PID threshold template assigned to the
Service thresholds: The name of the Service threshold template assigned to
VBC thresholds: The name of the VBC threshold template assigned to the
Spectrum inversion: Indicates whether the spectrum is inverted or not
Transponder: The SAT tuning frequency in GHz
Symbol rate: The SAT symbol rate in MSymb/s
Modulation: The SAT modulation scheme - may be QPSK, 8PSK, 16APSK
FEC rate: The forward error correction rate - may be 1/2, 2/3, 3/4, 4/5
Standard: The modulation standard - may be DVB-S1, DVB-S2, DSS or
2014 © BRIDGE Technologies Co AS - Bentsebrugata 20 - N-0476 Oslo, Norway - tel: +47 22 38 51 00 -
206
SAT status - SAT demod info:
The bit error rate after forward error correction
are due to either packet loss or packet bit errors
Signal to noise ratio in dB
no lock
expressed according to the level mode selection made in
the Setup - ETR view:
dBm: in decibels relative to a reference value of 1mW
dBuV: in decibels relative to a reference value of 1µ V
dBmV: in decibels relative to a reference value of 1mV
SAT status - SAT tuning info:
current frequency
current frequency
the current frequency
current frequency
LNB: The LNB frequency in GHz
or 32APSK
(for Turbocode only),5/6, 6/7 (for DSS only), 7/8 or 8/9 (for
Turbocode only)
Turbocode.
PROBE USERS' MANUAL VERSION 5.0
www.bridgetech.tv