BridgeTech VB20 User Manual page 107

For convenience a manual ping field is located below the status table. By entering a
valid IP address (not host name) and clicking the "ping now" button an arbitrary server
may be pinged.
The Clear all button will clear accumulated data for all enabled FSM services, but
active alarms will not be removed.
Clicking the Traceroute button will open a new window, allowing the user to trace the
network route to a specified IP address.
Ethernet - FSM - Setup
Each of the 10 FSM services may be defined or edited by clicking on the corresponding
Edit button in the left hand table.
The probe supports ping and generic HTTP-Get protocols for online status verification
of arbitrary targets. After completing configuration of the selected service Apply
changes must be pressed to save and apply the changes.
PROBE USERS' MANUAL VERSION 5.0
2014 © BRIDGE Technologies Co AS - Bentsebrugata 20 - N-0476 Oslo, Norway - tel: +47 22 38 51 00 -
www.bridgetech.tv
108