The Hardware Modules And Connectors (Vb220); The Probe Module - BridgeTech VB20 User Manual

License.

4.7 The Hardware Modules and Connectors (VB220)

The probe module is equipped with the following connectors:

4.7.1 The Probe Module

USB: USB serial port emulator for initial set-up of the probe – Type A
ASI INPUT: ASI transport stream input – 75 ohm SMB female
ASI OUTPUT: ASI transport stream output – 75 ohm SMB female
SFP: Alternative SFP input used when connecting to optical
T10/100/1000:
(Video – eth0)
MANAGEMENT:
(Management –
eth2)
A number of LEDs serve the following purposes:
POWER: Green power LED
ASI: Green LED indicating ASI sync
SFP LINK: Green LED indicating SFP link status
T10/100/1000: The green LED indicates link. The yellow LED indicates that the
MANAGEMENT: The green LED indicates link. If the yellow LED is active the
2014 © BRIDGE Technologies Co AS - Bentsebrugata 20 - N-0476 Oslo, Norway - tel: +47 22 38 51 00 -
22
networks
For monitoring a 10/100/1000 electrical/copper signal – RJ-45.
The probe can only monitor either the SFP input signal OR the
T10/100/1000 input signal (selected from software).
For optionally running management of the probe on a separate
network – RJ-45. This interface supports T10/100.
interface is receiving data (RX). Both LEDs are off if input is
taken from the SFP module.
speed is 100Mbps – otherwise the speed is 10Mbps.
PROBE USERS' MANUAL VERSION 5.0
www.bridgetech.tv