BridgeTech VB20 User Manual page 48

(Bulb): The RDP bulb indicates whether RDP is active or not. Green indicates
RDP active whereas grey indicates that RDP is currently not active.
Active: The RDP active state is either yes or no, yes indicating that RDP
relaying or alarm triggered recording mode has been selected by the
operator in the RDP view.
State: The current RDP state. The different RDP states are:
Idle : relaying or recording is not active and alarm triggered
recording has not been selected
Relaying (interface) : a transport stream or range of PIDs has been
selected for forwarding to an operator determined IP address
Trigger : the operator has selected alarm triggered recording mode
RECORDING : a stream is currently being recorded, either due to the
operator selecting manual recording or by an alarm triggering
recording
Clear all: Click the Clear all button to reset all counters, graphs and alarms.
All probe measurement and alarm history is cleared. Note that it is
not possible to undo this operation.
Last The time since the the Clear all counters button was last clicked. If
cleared: no time is indicated the counters have not been cleared since probe
startup/reboot time.
Name: The probe name as defined by the operator in the Setup - Params
view
Location: The probe location as defined by the operator in the Setup - Params
view
Access: The access rights of the current user. Access rights are either full
access or read only access.
CPU level: The CPU level indicates the workload of the probe, on a scale from 1
to 10 of total capacity.
Free mem: The available free probe memory
Free disk: The available free probe disk space
2014 © BRIDGE Technologies Co AS - Bentsebrugata 20 - N-0476 Oslo, Norway - tel: +47 22 38 51 00 -
RDP
Counters and alarms
Probe
Resources
PROBE USERS' MANUAL VERSION 5.0
www.bridgetech.tv
49