Alarm Codes - YASKAWA DX100 Instructions Manual

157449-1CD
Data Transmission
Function
5.4
Code Contents
4112 Data sending error
1 : NAK retry over
2 : Timer A timeup retry over
3 : Alternating response error retry over
4113 Data receiving error
1 : Receiving timeup (Timer A)
2 : Receiving timeup (Timer B)
3 : Short heading length
4 : Long heading length
5 : Illegal header No.
6 : Text longer than 256 characters
7 : Receiving other than expected control code
4114 Transmission hardware error
1 : Overrun error
2 : Parity error
3 : Framing error
4 : Sending timeup (Timer A)
5 : Sending timeup (Timer B)
4115 Transmission system block
This alarm notifies that the transmission procedure is correct
but the received contents makes inconsistency in the system.
Usually this alarm is resulted from violation of rules on the
other party or illegal notification.
1 : EOT was received while waiting for ACK
2 : EOT was received while waiting for ENQ
3 : EOT was received before receiving the last block
4 : Code other than EOT was received after receiving the last
block
4206 Transmission system error
This alarm notifies an error on processing of transmission
system. This alarm occurs in the following cases.
100 Error in transmission task
• A job containing position type variable of which the
value is not set, was to be saved.
• A job which does not exist on the memory, was to be
saved.
5 Host Control Function of DX100

5.4 Alarm Codes

Alarm Codes
5-52
Remarks
The EOT code is sent out and the data
link is canceled.
For 3 to 7, the EOT code is sent out and
the data link is canceled.
The EOT code is not sent.
For 4, the EOT code is sent out and the
data link is canceled.
The EOT code is not sent.
RE-CKI-A456
113 of 125