Display In Command Remote Mode - YASKAWA DX100 Instructions Manual

Data Transmission
Function

2.1.3 Display in Command Remote Mode

2 For Using Data Transmission Function
2.1 Remote Mode
Even in command remote enabled submode, it is not necessary to call the
command remote display because operations from DX100 is available.
To call the command remote display, select "REMOTE" from "I/O" under
the top menu.
This display is used in common with the I/O remote mode display.
The message in the remote display changes according to the remote
function selection. (Refer to chapter 8 "Remote Function Setting".)
Remote Select Status Message
I/O Command
Remote Remote
× ×
"Remote mode not
specified"
×
 "I/O mode"
× "Command mode"

  "I/O and Command mode"
Read-only Function "Remote mode not
Valid specified"
 : Valid, × : Invalid
2-4
157449-1CD
A message shown in
the table below is displayed.
Remarks
Same when the remote
lamp is OFF.
Only when the remote
lamp is ON.
"CURR" and "PREV" are
displayed.
RE-CKI-A456
20 of 125