Parallel Operation Of Dx100; No Multiple-Operation Of Dci, Stand-Alone, And Host Control Functions; File Access And Editing For A Single Target - YASKAWA DX100 Instructions Manual

Data Transmission
Function
2.3
2.3.1 No Multiple-operation of DCI, Stand-alone, and Host Control

2.3.2 File Access and Editing for a Single Target

2 For Using Data Transmission Function

2.3 Parallel Operation of DX100

Parallel Operation of DX100
The DX100 is capable of parallel processing.
For instance, it can check signals with programming pendant while saving
files to YASNAC FC2, or can edit files with the programming pendant
while monitoring operation status by the host control function.
The parallel operation has the following restrictions. When an operation
against these restrictions is made, a warning message is displayed.
Operation
YASNAC FC2
Stand-alone
Programming pendant
DCI
Host control
Functions
All DCI, stand-alone, and host control use BSC LIKE protocol and the
same port, therefore these functions cannot be performed by parallel
processing.
Warning message: Serial port not defined
Warning message: Serial port being used
Warning message: Protocol being used
Access to a single target file is available. Parallel processing of reads from
two or more sources is impossible.
During access to a file for other function, the HLOCK command of the host
control function cannot be issued.
Key operations are ignored while the HLOCK command is ON.
Warning message : Data accessed with other functions
2-6
Warning
Error message for 3 seconds
Alarm
Interpreter message
(or error message)
RE-CKI-A456
157449-1CD
22 of 125