Chapter 6 Speed Dome Configuration; Configuring Network Settings; Basic Settings - HIKVISION E Series User Manual
Network speed dome
Hide thumbs
Also See for E Series:
- User manual (117 pages) ,
- Installation manual (42 pages) ,
- Quick manual (40 pages)
Table of Contents
Advertisement
User Manual of E Series Network Speed Dome
Chapter 6 Speed Dome Configuration
6.1 Configuring Network Settings
The functions vary depending on the models of speed dome.
6.1.1 Basic Settings
Configuring TCP/IP Settings
Purpose:
TCP/IP settings must be properly configured before you operate the speed dome over network.
IPv4 and IPv6 are both supported.
Steps:
1.
Enter TCP/IP settings interface:
Configuration > Network > Basic Settings > TCP/IP
2. Configure the NIC settings, including the IPv4(IPv6) Address, IPv4(IPv6) Subnet Mask and
IPv4(IPv6) Default Gateway.
Figure 6-1 TCP/IP Settings
66
Advertisement
Table of Contents
