HIKVISION E Series User Manual page 61

User Manual of E Series Network Speed Dome
5. Draw area.
1) Click
2) Click the line to switch to the editing mode.
Click and drag an end to the desired place to adjust the length and angle of the line. And
click and drag the line to adjust the location.
Up to four lines are supported.
6. Configure the parameters for each defense region separately.
 Direction: Select the detection direction in the dropdown list, there are A<->B, A->B and
B->A selectable.
 Sensitivity: Range [1-100]. The value of the sensitivity defines the size of the object which
can trigger the alarm, when the sensitivity is high, a very small object can trigger the
alarm.
7. Click
schedule configuration is the same as the settings of the arming schedule for motion
detection. Refer to Section 5.2.1 Configuring Motion Detection.
8. Click
Notify Surveillance Center, Send Email, Upload to FTP/Memory Card/NAS, Trigger Alarm
Output and Trigger Recording are selectable. Refer to Section 5.2.1 Configuring Motion
Detection.
Figure 5-23 Configuring Line
to draw a line on the image.
tab to enter the arming schedule setting interface. The time
tab to select the linkage method taken for the line crossing detection,
54