Chapter 2 Network Connection; Setting The Network Speed Dome Over The Lan; Wiring Over The Lan - HIKVISION E Series User Manual

User Manual of E Series Network Speed Dome

Chapter 2 Network Connection

Before you start:

If you want to set the network speed dome via a LAN (Local Area Network), please refer to
Section 2.1.

If you want to set the network speed dome via a WAN (Wide Area Network), please refer to
Section 2.2.

2.1 Setting the Network Speed Dome over the LAN

Purpose:
To view and configure the speed dome via a LAN, you need to connect the network speed dome
in the same subnet with your computer, and install the SADP or client software to search and
change the IP of the network speed dome.
For the detailed introduction of SADP, please refer to Appendix.

2.1.1 Wiring over the LAN

The following figures show the two ways of cable connection of a network speed dome and a
computer:
Purpose:

To test the network speed dome, you can directly connect the network speed dome to the
computer with a network cable as shown in Figure 2-1.

Refer to the Figure 2-2 to set the network speed dome over the LAN via a switch or a router.
Speed Dome
Network Cable
Figure 2-1 Connecting Directly
Network Cable
Switch or Router
Figure 2-2 Connecting via a Switch or a Router
Network Cable
PC
4