HIKVISION E Series User Manual page 65

User Manual of E Series Network Speed Dome
2. Configure the following settings:
 Basic Parameters: Enable/disable PTZ control, proportional pan and preset freezing, set the
preset speed, keyboard control speed, and auto scan speed.

PTZ Control: By default, PTZ Control function is enabled .You can uncheck the checkbox
to disable the PTZ control function.
The PTZ Control function varies depending on the models of speed dome.

Proportional Pan: If you enable this function, the pan/tilt speeds change according to
the amount of zoom. When there is a large amount of zoom, the pan/tilt speed will be
slower for keeping the image from moving too fast on the live view image.

Preset Freezing: This function enables the live view to switch directly from one scene
defined by a preset to another, without showing the middle areas between these two, to
ensure the surveillance efficiency. It can also reduce the use of bandwidth in a digital
network system.
Preset freezing function is invalid when you calling a pattern.

Preset Speed: You can set the speed of a defined preset from 1 to 8.

Manual Control Speed: The speed dome provides 5 control speed modes: Compatible,
Pedestrian, Non-motor Vehicle, Motor Vehicle and Auto. Select it from the dropdown list.

Keyboard Control Speed: Define the speed of PTZ control by a keyboard as Low, Medium
or High.

Auto Scan Speed: The scan speed can be set from level 1 to 40.

ax. Tilt-angle: Set the tilt-angle of the speed dome from the dropdown list.
M
Figure 5-26 Basic PTZ Configuration Interface
58