HIKVISION E Series User Manual page 44

User Manual of E Series Network Speed Dome
2. Click
3. Select the timeline of a certain day, click and drag the left button of the mouse to set
the capture schedule (the start time and end time of the recording task).
4. After you set the scheduled task, you can click
(optional).
5. After setting the capture schedule, you can click a capture segment to display the
segment capture settings interface to edit the segment capture parameters. (optional)
6. Click
of the capture.
7. Click
8. Check the Enable Timing Snapshot checkbox to enable continuous snapshot, and
configure the schedule of timing snapshot. Check the Enable Event-triggered Snapshot
checkbox to enable event-triggered snapshot.
9. Select the format, resolution, quality of the snapshot.
10. Set the time interval between two snapshots.
11. Click
Uploading to FTP
Please make sure that the FTP server is online.
You can follow below configuration instructions to upload the snapshots to FTP.

Upload continuous snapshots to FTP
Steps:
1) Configure the FTP settings and check Upload Picture checkbox in FTP Settings interface.
Please refer to Section 6.1.2 Configuring FTP Settings for more details to configure FTP
parameters.
2) Check the Enable Timing Snapshot checkbox.
3) Click Edit to set the snapshot schedule. Refer to Section 5.2.1 Configuring Motion
Detection.

Upload event-triggered snapshots to FTP
to enter the Capture Schedule interface.
Figure 5-4 Segment Snapshot Settings
to enter the advanced setting interface. You can select the stream type
to enter the Capture Parameters Interface.
to save the settings.
and copy the task to other days
37