HIKVISION E Series User Manual page 104

User Manual of E Series Network Speed Dome
you can turn this function on. The time will be adjusted automatically when the Daylight Saving
Time (DST) comes.
Steps:
1. Enter the DST interface by Configuration > Advanced Configuration > System > DST
2. Check
3. Set the date of the DST period.
4. Click
Configuring RS-485
Purpose:
The RS-485 serial port is used to control the PTZ of the camera. The configuring of the PTZ
parameters should be done before you control the PTZ unit.
Steps:
1.
Enter RS-485 Port Setting interface:
Configuration> Advanced Configuration> System > RS-485
2. Set the RS-485 parameters and click
The Baud rate, PTZ Protocol and PTZ Address parameters of the speed dome should be exactly
the same as those of the control device.
Figure 6-50 DST Settings
to enable the DST function.
to save the settings.
Figure 6-51 RS-485 Settings
to save the settings.
97