Configuring Capture Schedule - HIKVISION E Series User Manual

User Manual of E Series Network Speed Dome
information, please refer to Section Alarm Input.

Record Triggered by Motion & Alarm: If you select Motion & Alarm, the video will be
recorded when the motion and alarm are triggered at the same time. Besides
configuring the recording schedule, you have to configure the settings on the Motion
Detection and Alarm Input settings interfaces.

Record Triggered by Motion | Alarm: If you select Motion | Alarm, the video will be
recorded when the external alarm is triggered or the motion is detected. Besides
configuring the recording schedule, you have to configure the settings on the Motion
Detection and Alarm Input settings interfaces.

Record Triggered by VCA events: If you select VCA, the video will be recorded when the
either of the VCA events is triggered. Besides configuring the recording schedule, you
have to configure the settings on the VCA interface.
VCA function varies depending on the models of speed dome.

Record Triggered by Event: If you select to record by event, the video will be recorded
when any of the events is triggered.
6. Click

5.1.2 Configuring Capture Schedule

Purpose:
You can configure the scheduled snapshot and event-triggered snapshot. The captured picture
can be stored in the local storage or network storage.
Steps:
1. Enter the Snapshot settings interface:
Configuration > Storage > Storage Settings > Capture
to save the settings.
Figure 5-3 Snapshot Settings
36