Configuring Net Hdd - HIKVISION E Series User Manual

User Manual of E Series Network Speed Dome
Steps:
1) Configure the FTP settings and check Upload Picture checkbox in FTP Settings interface.
Please refer to Section 6.1.2 Configuring FTP Settings for more details to configure FTP
parameters.
2) Check Upload to FTP checkbox in Motion Detection Settings or Alarm Input interface. Refer
to Section 5.2.1 Configuring Motion Detection.
3) Check the Enable Event-triggered Snapshot checkbox.

5.1.3 Configuring Net HDD

Before you start:
The network disk should be available within the network and properly configured to store the
recorded files, log files, etc.
Steps:

Add the network disk
1. Enter the NAS (Network-Attached Storage) settings interface:
Configuration > Storage > Storage Management > Net HDD
2. Enter the IP address and the file path of the network disk.
3. Select the mounting type. NFS and SMB/CIFS are selectable. You can set the user name and
password to guarantee the security if SMB/CIFS is selected.
Please refer to the NAS User Manual for creating the file path.

For your privacy and to better protect your system against security risks, we strongly
recommend the use of strong passwords for all functions and network devices. The
password should be something of your own choosing (using a minimum of 8 characters,
including upper case letters, lower case letters, numbers and special characters) in order
to increase the security of your product.

Proper configuration of all passwords and other security settings is the responsibility of
the installer and/or end-user.
Figure 5-5 Select Net HDD Type
38