Basic Event Configuration; Configuring Motion Detection - HIKVISION E Series User Manual

User Manual of E Series Network Speed Dome

Up to 8 NAS disks can be connected to the speed dome.

To initialize and use the memory card after insert it to the speed dome, please refer to the
steps of NAS disk initialization

5.2 Basic Event Configuration

Purpose:
This section explains how to configure the network speed dome to respond to alarm events,
including motion detection, video tampering alarm input, alarm output and exception. These
events can trigger the alarm actions, such as Send Email, Notify Surveillance Center, etc.
For example, when motion detection is triggered, the network speed dome sends a notification
to an e-mail address.

On the event configuration page, click

Click the direction buttons to control the pan/tilt movements.

Click the zoom/iris/focus buttons to realize lens control.

The functions vary depending on the models of speed dome.

5.2.1 Configuring Motion Detection

Purpose:
Motion detection is a feature which can trigger alarm actions and actions of recording videos
when the motion occurred in the surveillance scene.
Steps:
1. Enter the motion detection setting interface:
Configuration > Event > Basic Event > Motion Detection
2. Check the checkbox of the Enable Motion Detection to enable this function.
You can check the Enable Dynamic Analysis for Motion checkbox if you want the detected
object get marked with rectangle in the live view.
3. Select the configuration mode as Normal or Expert and set the corresponding motion
detection parameters.

Normal
to show the PTZ control panel or click
40
to hide it.