Edit An Ipv6 Interface; Ipv6 Link-Local Address Setup - ZyXEL Communications XMG1915 Series User Manual

Table 53 SYSTEM > IPv6 > IPv6 Interface Setup (continued)
LABEL
Edit

24.4.1 Edit an IPv6 Interface

Use this screen to turn on or off an IPv6 interface you create in the SYSTEM > Interface Setup screen.
Select an entry and click Edit in the SYSTEM > IPv6 > IPv6 Interface Setup screen to display the screen as
shown next.
Figure 95 SYSTEM > IPv6 > IPv6 Interface Setup > Edit
The following table describes the labels in this screen.
Table 54 SYSTEM > IPv6 > IPv6 Interface Setup > Edit
LABEL
Interface
Active
Apply
Clear
Cancel

24.5 IPv6 Link-Local Address Setup

A link-local address uniquely identifies a device on the local network (the LAN). It is similar to a "private IP
address" in IPv4. You can have the same link-local address on multiple interfaces on a device. A link-
local unicast address has a predefined prefix of fe80::/10.
Use this screen to view and configure the interface's link-local address and default gateway. Click
SYSTEM > IPv6 > IPv6 Addressing > IPv6 Link-Local Address Setup to display the screen as shown next.
Note: You should first create an IPv6 interface in the SYSTEM > Interface Setup screen.
Chapter 24 IPv6
DESCRIPTION
Select an entry's check box to select a specific entry.
Click Edit to edit the selected interface.
DESCRIPTION
Select the IPv6 interface you want to configure.
Enable the switch button to enable the interface.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Click Clear to clear the fields to the factory defaults.
Click Cancel to not save the configuration you make and return to the last screen.
XMG1915 Series User's Guide
143