3 OPERATOR VIEWS
3.1 View Set Points
Note. The parameter names and units of measurement displayed in the
settings for Sensors A and B – see Section 5.3. Those shown below are given as examples only.
-----
VIEW SETPOINTS
Sen.A
8. 3 0
pH
A1: Setpoint
Temp.A
35. 0
Deg.C
A2: Setpoint
Sen.B
6. 8 0
pH
A3: Setpoint
Temp.B
55. 0
Deg.C
A4: Setpoint
-----
Off
A5: Setpoint
VIEW SETPOINTS
12
View Set Points
This page shows alarm set points. The value of each of the set points is shown, together
with the name of the parameter it is assigned to.
Alarm assignments, set point values and relay/LED actions are programmable – see
Section 5.4.
Sensor A (pH), Alarm 1 Set Point
Sensor A (Temperature), Alarm 2 Set Point
Sensor B (pH), Alarm 3 Set Point – Dual input analyzers only
Sensor B (Temperature), Alarm 4 Set Point – Dual input analyzers only
Note. Alarm 4 available only if option board fitted and analog features enabled – see
Section 7.3.
Alarm 5 Set Point
Note. Alarm 5 available only if option board fitted and analog features enabled – see
Section 7.3.
See Section 3.2.
VIEW OUTPUTS
SENSOR CAL.
See Note on next page.
Security Code
CONFIG. DISPLAY
page depend on the
View Set Points
Probe Type