Operator Views; View Setpoints - ABB AX416 User Manual

Single and Dual Input Analyzers for pH/Redox (ORP)
AX416, AX436, AX460, AX466 & AX468

3 OPERATOR VIEWS

3.1 View Set Points
Note. The parameter names and units of measurement displayed in the
for Sensors A and B - see section 5.3, page 30. Those shown below are given as examples only.
-----

VIEW SETPOINTS

Sen.A
pH
8. 3 0
A1: Setpoint
Temp.A
Deg.C
35. 0
A2: Setpoint
Sen.B
pH
6. 8 0
A3: Setpoint
Temp.B
Deg.C
55. 0
A4: Setpoint
Off
-----
A5: Setpoint
VIEW SETPOINTS
12
View Set Points
This page shows alarm set points. The value of each of the set points is shown,
together with the name of the parameter it is assigned to.
Alarm assignments, set point values and relay/LED actions are programmable - see
section 5.4, page 33.
Sensor A (pH), Alarm 1 Set Point
Sensor A (Temperature), Alarm 2 Set Point
Sensor B (pH), Alarm 3 Set Point - Dual input analyzers only
Sensor B (Temperature), Alarm 4 Set Point - Dual input analyzers only
Note. Alarm 4 available only if option board fitted and analog features enabled - see
section 7.3, page 58.
Alarm 5 Set Point
Note. Alarm 5 available only if option board fitted and analog features enabled - see
section 7.3, page 58.
VIEW OUTPUTS See Section 3.2.
SENSOR CAL.
Security Code
See Note on next page.
CONFIG. DISPLAY
page depend on the
View Set Points
3 OPERATOR VIEWS
settings
Probe Type
IM/AX4PH Issue 9