Operator Views; View Set Points - ABB AnalyzeIT AX460 User Manual

3 OPERATOR VIEWS

3.1 View Set Points

Notes.
• The View Set Points page replaces the View Set Points page shown in Section 3.1 of the User Guide, IM/AX4PH.
• The parameter names and units of measurement displayed in the View Set Points page depend on the Probe Type setting for
Sensor A in the
CONFIG. SENSORS
-----
VIEW SETPOINTS
-----
Off
A1: Setpoint
-----
Off
A2: Setpoint
Sen.A
6. 8 0
pH
A3: Setpoint
Temp.A
55. 0
Deg.C
A4: Setpoint
-----
Off
A5: Setpoint
VIEW SETPOINTS
10
page – see User Guide, Section 5.3. Those shown below are given as examples only.
View Set Points
This page shows alarm set points. The value of each of the set points is shown, together
with the name of the parameter it is assigned to.
Set point values and relay/LED actions are programmable – see User Guide, Section 5.4.
Sensor A (pH), Alarm 1 Set Point
Note. If is set to
Controller PID
4.3), is set to
A1: Set Point Off
User Guide, Section 5.4.
Sensor A (Temperature), Alarm 2 Set Point
Note. If is set to
Controller Dual
to or (see Section 4.3.2),
Time Pulse
the page – see User Guide, Section 5.4.
CONFIG. ALARMS
Alarm 3 Set Point
Alarm 4 Set Point
Note. Alarm 4 is available only if the optional analog output board is fitted.
Alarm 5 Set Point
Note. Alarm 5 is available only if the optional analog output board is fitted.
VIEW OUTPUTS Return to main menu.
SENSOR CAL. Sensor calibration enabled (User Guide, Section 5.3) – see User Guide,
Section 4.1.
Security Code
Alter Sec. Code
Section 5.1.
CONFIG. DISPLAY
Alter Sec. Code
Section 5.2.
or and is set to
Dual Output Type
, regardless of the setting in the
(see Section 4.3) and
Output Type
is set to
A2: Set Point
not set to zero (User Guide, Section 5.7) – see User Guide,
set to zero (User Guide, Section 5.7) – see User Guide,
or (see Section
Time Pulse
page – see
CONFIG. ALARMS
for is set
Base Controller
, regardless of the setting in
Off