User Log - Siemens 7SJ82 Manual

Figure 3-8
Reading the Ground-Fault Log on the On-Site Operation Panel of the
Device
Deletability
The ground-fault log of your SIPROTEC 5 device can be deleted. Read details about this in chapter
and Deleting the
Configurability
The indication scope of the ground-fault log is configured in a specifically defined column of the information
routing (matrix) of DIGSI 5:
Target → Log → Column Ground-fault log
Selected application templates and functions from the library already bring a predefined set of operational
indications with them which you can adjust individually at any time.
3.1.5.5

User Log

With the user-defined log (up to 2), you have the possibility of individual indication logging parallel to the
operational log. This is helpful, for example, in special monitoring tasks but also in the classification into
different areas of responsibility of the logs. Up to 200 indications can be stored in the user-defined log.
Reading from the PC with DIGSI 5
•
To reach the user-defined log of your SIPROTEC 5 device, use the project-tree window.
Project → Device → Process Data → Log → User log 1/2
The status of the user-defined log last loaded from the device is shown to you.
•
To update (synchronization with the device) click the button Read log entries in the headline of the indi-
cation list (Figure 3-9
[scanwnmd-030211-01, 2, en_US]
Figure 3-9
SIPROTEC 5, Overcurrent Protection, Manual
C53000-G5040-C017-8, Edition 07.2017
Logs.
a)).
Reading the User-Defined Log with DIGSI 5
System Functions
3.1 Indications
3.1.6 Saving
73