Siemens 7SJ82 Manual page 103

Quality Attribute: Test
The input signal source is in a test state
and the function to be processed is in
normal state.
Quality Attribute OperatorBlocked
The quality cannot be influenced at this position and does not lead to a response within the logic
Output Data
The quality is not processed through the actual algorithm/logic of the function. The following table displays
the conditions required to set the quality of output signals of a function.
Cause
Functional state = Test
(thus, result of device operating
mode = Test or function mode
= Test)
Functional state = Off
(thus, result of device operating
mode = Off)
Function health = Alarm
(for example, result of invalid
receive data)
Device operating mode = func-
tionally logged off
SIPROTEC 5, Overcurrent Protection, Manual
C53000-G5040-C017-8, Edition 07.2017
The data value of the source signal is ignored. You can select
between the following options:
•
Further processing of the last valid source signal data value,
before the source switches to the test state (that is the
default setting)
•
The binary value to be processed further is set to 0.
•
The binary value to be processed further is set to 1.
This configuration option is necessary to satisfy different applica-
tions.
D0 Value
Unchanged
Function-specific, corre-
sponding to the definition for
switched off
Function-specific, corre-
sponding to the definition for
reset
Unchanged
3.3 Processing Quality Attributes
Quality Attribute
After internal (to To the IEC 61850
the SIPROTEC 5 interface, in buffer
system, for example,
in the direction of a
CFC chart)
Test = Test =
TRUE
Validity = Validity =
good
Validity = Validity =
good
Validity = Validity =
good
OperatorBlocked = detailQual =
TRUE oldData
OperatorBlocked =
TRUE
System Functions
TRUE
invalid
invalid
good
103