Table of Contents
Advertisement
Supplies
In addition to the hardware included with your accessory, you will need the following
supplies:
• Drill with various drill bits
• Phillips Head Screw Driver
• Allen wrench
• Hex socket wrench or nut driver
• Electrical Tape
• Awl or Pencil
• Marine-grade silicone caulk or sealant
• Cable ties for cable routing
• Tape measure
• 1 Amp fuse
• Safety goggles
• Dust mask
Switch (optional): If you do not have a main switch or fuse panel available on
your boat to connect power, you will need to purchase a battery switch. See
Install the Trolling Motor Bracket, Section 3: Route the Cables and
Connect Power for more information.
• HELIX Series with Ethernet: To connect the Ethernet to the control head,
you will need to purchase the Ethernet Adapter Cable (AS EC QDE).
• Extension Cables are available for Ethernet and the GPS Receiver/Heading
Sensor.
Introduction
2
Hide quick links:
Advertisement
Table of Contents
