Humminbird Trolling Motor 360 Imaging Installation Manual page 25

Adjust the Pod Height
1. Deploy the Trolling Motor.
2. Loosen the socket bolts on the bracket where the pod shaft is installed.
Adjust the pod shaft up or down, so it meets the following height
requirements:
• The pod must be mounted approximately 6" (152.4 mm) below the
waterline.
• The pod must be mounted at least 1" (25.4 mm) off the tip of the
propeller.
• The pod shaft needs to protrude at least 1" to 2" (25.4 mm to 50.8 mm)
above the bracket when it is installed.
19 AS 360 TM Ultrex