Humminbird Trolling Motor 360 Imaging Installation Manual page 41

4. Power: Route the power cable to the main switch or fuse panel (usually
located near the console). If you must connect to a battery, connect to a
battery switch (not included).
5a. Main Switch/Fuse Panel: If a fuse terminal is
available, use crimp-on type electrical
connectors (not included) that match the
terminal on the fuse panel. Attach the black
wire to ground (–), and the red wire to positive
(+) 12 VDC power. Install a 1 Amp fuse (not
included) for protection of the unit.
OR
5b. Battery Switch: Install the battery switch (not
included) using the instructions provided with
it. You will also need to obtain and install an
inline fuse holder and a 1 Amp fuse (not
included) for the protection of the unit. Attach
the black wire to ground (–), and the red wire
to positive (+) 12 VDC power.
WARNING! If you are unable to obtain a battery switch and are forced to connect
the power cable directly to the battery, be aware that this will drain the battery.
Humminbird does not recommend connecting to a battery without the appropriate
fuse and a switch.
6. Tape the drain wire.
7. Secure the cables with cable ties along the route as needed for a clean
assembly.
Connecting to the Fuse Panel
35 Cable Installation