Humminbird Trolling Motor 360 Imaging Installation Manual page 28

Install the Collar Clamp
After you have established the pod height is no closer than 1 inch from the tip of the
propeller, install the collar clamp to prevent the trolling motor from hitting the
transducer pod.
1. Apply anti-seize to the end of each 1" socket bolt (1/4-20 x 1").
2. Install a 1" socket bolt (1/4-20 x 1") into the hole on 1 clamp half.
3. Place the bumper into the groove of the trolling motor shaft. Center one
clamp half over the bumper as shown in the illustration.
4. Install a washer, the clamp (half), and hex nut (1/4-20) onto the trolling motor
shaft as shown in the illustration. Repeat on the other side.
nut
NOTE: If your installation kit does not include a washer, you may skip the washer
portion of the installation.
5. Use an Allen wrench (not included) to tighten the hardware just enough to
keep the collar assembled.
6. Slide the collar up to the base of the BowGuard.
7. Use an Allen wrench (not inluded) to fully tighten the socket bolts until they
are secure. Hand-tighten only!
AS 360 TM Ultrex
Installing the Coller Clamp
bumper
clamp
groove in trolling
motor shaft
washer
22
socket bolt
(1/4-20 x 1")
clamp