Install The Trolling Motor Bracket; Prepare For Installation - Humminbird Trolling Motor 360 Imaging Installation Manual

Install the Trolling Motor Bracket

Use the following instructions to install the Trolling Motor 360 Imaging. It is important
to read the instructions completely and understand the mounting guidelines before
you start the installation.
1

| Prepare for Installation

1. Disconnect the motor from all sources of electrical power.
2. Test run the Ethernet cable from the chosen mounting location on the trolling
motor to the control head (or optional Ethernet Switch). Test run the power
cable from the chosen mounting location on the trolling motor to the main
switch or fuse panel.
It is important to consider the following:
• The 360 Imaging transducer pod is powered separately from the control
head. It must be connected to a switch where it can be powered on
when the boat is underway and powered off when it is docked.
• The cables should be routed through an established routing system on
the boat, in an area with minimal interference, without sharp edges,
obstacles, or obstructions that may damage the cables.
• The cables will move with the trolling motor when it is deployed and
retracted, so it is important to allow enough length for movement.
3. With the trolling motor deployed, the transducer pod has the following
installation requirements:
• The transducer pod should not have anything obstructing the 'view' of
the rotating beams (besides the trolling motor and shaft). If possible,
move anything to the sides and below the pod that might obstruct the
sight line of the rotating beams.
• The pod must be mounted at least 1" (25.4 mm) off the tip of the
propeller.
• AS TM 360 Ultrex: The pod should be submerged 6" (152.4 mm) below
the waterline. The height may be adjusted, however, the pod must be
mounted 1" (25.4 mm) off the tip of the propeller.
13 Trolling Motor Bracket