Humminbird Trolling Motor 360 Imaging Installation Manual page 40

WARNING! The 360 Imaging transducer should be connected to a
main switch, fuse panel, or battery switch. Humminbird does not
recommend connecting to a battery without a fuse and a switch.
NOTE: Humminbird is not responsible for over-voltage or over-current failures. The
360 Imaging transducer must have adequate protection through the proper selection
and installation of a 1 Amp fuse.
NOTE: A 3' (1 m) power cable is included to supply power to the 360 Imaging
transducer. You may shorten or lengthen the cable using 18 gauge multi-stranded
copper wire.
CAUTION! Some boats have 24 or 36 Volt electric systems, but the 360 Imaging
transducer MUST be connected to a 12 VDC power supply.
Cable Installation
HELIX 7 Control Head Ports
Ethernet power
HELIX 9, 10, 12 Cable Tray
transducer
pin Ethernet
COM
(communications)
transducer
Optional: Use a Y-Cable
to connect Transducer and
Speed Sensor Accessory
COM
(communications)
temp/speed
34
power
pin