Requirements For The Circuit Wiring - Rotax 912 i Series Installation Manual

1) Requirements for the circuit wiring

General note
NOTE:
Effectivity: 912 i Series
Edition 1/Rev. 2
BRP-Powertrain
INSTALLATION MANUAL
The connections have to be made by the aircraft man-
NOTICE
WARNUNG
ufacturer in accordance with applicable regulations
and the enclosed wiring diagram.
See chap. 24-00-00 section:
Switch requirements and warning lamps.
The power supply to the various consumers (e.g. bat-
NOTICE
WARNUNG
tery) must be adequately protected by fuses. Using in-
correctly rated fuses may result in destruction of the
equipment.
Under no circumstances must consumer cables (e.g.
battery) be routed alongside the ignition cable. There
is a risk of electromagnetic interference or damage.
Do not bend, kink, pinch or otherwise improperly
NOTICE
WARNUNG
stress the wiring harness. Use proper routing, clamp-
ing and strain relief on wiring harnesses.
Follow the relevant building regulations (licensing condi-
tions) of the maintenance staff, during manufacturing of
the wiring harness and repairs or modifications of the air-
craft.
24-00-00
Page 3
January 01/2014