Data Formats - Fuji Electric FRENIC-AQUA series User Manual

5.2

Data Formats

5.2.1 List of data format numbers
The following table shows the communications data format numbers for function code data.
Create data according to the data format specifications described below. For the data setting
range and setting unit, see the FRENIC-HVAC/AQUA User's Manual (Chapter 5.) The "Support"
column of the table indicates whether each function is supported by the respective models or
indicates the function is supported, and × indicates the function is not supported.
not.
RTU and FGI in the Format number field mean the Modbus RTU protocol and the Fuji
general-purpose inverter protocol, respectively.
Code
F00 Data Protection
F01 Frequency Command 1
F02 Operation Method
F03 Maximum Frequency 1
F04 Base Frequency 1
F05 Rated Voltage at Base Frequency 1
F06 Maximum Output Voltage 1
F07 Acceleration Time 1
F08 Deceleration Time 1
F09 Torque Boost 1
F10 Electronic Thermal Overload Protection for Motor
F11
F12
F14 Restart Mode after Momentary Power Failure
F15 Frequency Limiter
F16
F18 Bias
F20 DC Braking 1
F21
F22
F23 Starting Frequency 1
F24 Starting Frequency 1
F25 Stop Frequency
F26 Motor Sound
F27
*1 BUS: The field bus option format is selected. For details about the field bus option, see the
instruction manual for each field bus option.
*2 The frequency of 0.75 kHz will be treated as 0.
Table 5.15 List of data format numbers (F codes)
Name
(Select motor characteristics)
(Overload detection level)
(Thermal time constant)
(Mode selection)
(Frequency command 1)
(Braking starting frequency)
(Braking level)
(Braking time)
(Holding time)
(Carrier frequency)
5-32
Format number
[1]
[1]
[1]
[3]
[3]
[1]
[1]
[12]
[12]
[3]
[1]
[24] (FGI)
[19] (RTU)
[24] (BUS) *1
[3]
[1]
(High) [3]
(Low) [3]
[6]
[3]
[1]
[5]
[3]
[5]
[3]
[1] *2
(Tone) [1]
Support
HVAC AQUA