Operator Maintenance - JLG E600 Service And Maintenance Manual

1.13 OPERATOR MAINTENANCE

NOTE: The following numbers correspond to those in Fig-
ure 1-2., Operator Maintenance and Lubrication
Diagram.
Table 1-15. Lubrication Specifications.
KEY
MPG Multipurpose Grease having a minimum dripping point of
350 degrees F. Excellent water resistance and adhesive
qualities; and being of extreme pressure type (Timken OK
40 pounds minimum).
EPGL Extreme Pressure Gear Lube (oil) meeting API Service
Classification GL-5 or Mil-Spec Mil-L-2105.
HO Hydraulic Oil. Mobil DTE-11M
OG* Open Gear Lube - Tribol Molub-Alloy 936 Open Gear Com-
pound. (JLG Part No. 3020027)
BG* Bearing Grease (JLG Part No. 3020029) Mobilith SHA
460.
LL Synthetic Lithium Lubricant, Gredag 741 Grease. (JLG
Part No. 3020022)
EO Engine (crankcase) Oil. Gas - API SF/SG class, MIL-L-
2104. Diesel - API CC/CD class, MIL-L-2104B/MIL-L-
2104C.
*MPG may be substituted for these lubricants, if neces-
sary, but service intervals will be reduced.
3121813
2
1
5
3,4
Figure 1-2. Operator Maintenance and Lubrication Diagram
SPECIFICATIONS
6
6
LUBRICATION INTERVALS ARE BASED ON MACHINE OPERATION
UNDER NORMAL CONDITIONS. FOR MACHINES USED IN MULTI-
SHIFT OPERATIONS AND/OR EXPOSED TO HOSTILE ENVIRON-
MENTS OR CONDITIONS, LUBRICATION FREQUENCIES MUST BE
INCREASED ACCORDINGLY.
NOTE: It is recommended as a good practice to replace all
filters at the same time.
1. Swing Bearing - Internal Ball Bearing
Lube Point(s) - 1 Grease Fittings
Capacity - A/R
Lube - MPG
Interval - Every 3 months or 150 hrs of operation
– JLG Lift –
SECTION 1 - SPECIFICATIONS
1-5